About this 3D model

The Waxy Monkey Tree Frog is the largest tree frog in the world. With their angular large heads, spots, and ridges they are on of the coolest frogs out there. This guy was fun to model and took us out of the comfort zone a little. Besides realism we also were looking for a compromise in the legs. Making them flexible and NOT too wobbly. While they can utilize glass eyes I am not sure I don’t like 3d printed eyes better, but the choice is yours (12mm at 100%). This model is also VERY scalable. 50% is doable but as always your milage my vary. PLEASE READ:All Raki-Box designs are protected under Copyright Law.Your purchase gives you the right to download and print the design for your personal use. You do NOT have permission to resell or redistribute those digital files in ANY way. This includes altered or "remixed" versions of the designs. Prints of the design cannot be sold without authorization. To sell PRINTS of my designs, you must obtain authorization by joining the "Commercial" Tier of our Patreon or MMF Tribe. If you like this design, please check out our Socials and give a follow. Warning: Not suitable for unsupervised play by small children or pets, as small parts can pose a choking hazard if broken off due to rough play. Furthermore, broken 3D-printed parts can create sharp edges and/or points. Not recommended for children under 3. PARTS: BodyHeadJawEyeEyeInner Mouth LowerInner Mouth UpperFull 3mf (4 color)Simple 3mf (2Color) Multi-Color There are a lot of options for multicolor. In fact you don’t need to really to use multicolor. Print the eyes one color, print the white parts, and print the body another color and you have a pretty good looking multicolor print without waste. Fast, easy and extremely good profit margin. The FULL 3mf will take a LONG time on a Bambu I assume. However, print the heads alone (single color) on one plate, Print a bunch of inner mouths (white) on another, and load as many bodies as you can on a third plate and it should be manageable. Same with the Simple, print bodies alone, and the heads, jaws and inner mouths on separate plates. ON THE FULL COLOR - The Belly/JAW are an off white, and the middle of the spots are a bright white Scaling SCALING IS PRINTER DEPENDENT. At 40% I had too many that were stiff, at 45% I was happy with the outcome on 8 different printers. Luckily it is a quick cheap print to check YOUR outcomes.. Eyes: 100% = 12mm eyes 83% - 10mm 67% - 8mm 50% - 6mm. ALWAYS TEST TO SEE IF YOU WANT TO GO UP ON DOWN A PERCENTAGE. Printing Parameters 3 walls 8% crosshatch/10% gyroid Inner mouths - I use 2 walls and 10% gyroid Enjoy the print Filament used Eryone - Gold, Blue, Green Eryone - Maple leaf Eryone - Dreamland Eryone - Gold Red Black Full Color - Bambu Matte Grass Green, Iidamx vanilla rose, Generic White