About this 3D model

It's been a long 3 months, but I finally think that the OpenFuge is presentable to you all. My goal was to make an affordable, open-source centrifuge for home-use by DIY biohackers. As of now, it costs around $200 in parts only, with all parts being commercial, off-the-shelf. The Instructables page will be up soon for all of you who want to build your own. Enjoy! Specs (Observed): G-Force: 6000 G's RPM: 9000 RPM Size (closed lid): 15cm x 24cm x 20cm For those who want to buy one: https://www.tindie.com/products/CopabX/openfuge/ Any comments, suggestions, or general feedback is greatly appreciated. 9/21/13: BOM Updated (wrong motor was listed)