About this 3D model

Figured I would share this on here, seeing what this site is all about. I also want to preface that I'm sure people can do this in their sleep, but I had a heck of a time finding an easy way to do this, and I figured I would share my set up. Also, the files are just an HTML file of the instruable, along with the image posted above. This project is to be used to control the heat bed of any 3D printer running Gen6, however, it can be used to run any 3D printer heat bed that can be properly powered with an ATX. This setup uses an ATX power supply, which also powers the Gen6 board. If you don't have an ATX power supply, it will be easy to implement one into a gen6 printer, or you could replace it with some other 12v power supply. The bread and butter of this is the PID heat controller. The markdown hates me, so have some raw link text to the one I used. http://www.ebay.com/itm/161040584256?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649 The PID needs 110v to it, which I used from the ATX (just got some aptly rated wire from the ATX plug to it's input) to run. I then snagged a pair of the 12v/GND wires from the ATX to the heating switch, which also was in circuit with the heat bed. And, of course, the sensor from the PID is stuck on the bottom of the heatbed. If something here wasn't clear enough (which, I won't blame you, I suck at tuts) check out the instructable I have posted. And, again, enjoy the raw (pun intended) power of the link http://www.instructables.com/id/Heatbed-temperature-controller-for-RepRap-using-Ge/ If you still need something, feel free to comment on this or the instructable page, or even private message me through either. Thanks for checking this out!