About this 3D model

I added a couple new cabinets to our kitchen, only to find out that Ikea is no longer selling the “Snodd” knob that we used on all the other cabinets. I designed a two tone layout that replicates the look of the “Snodd” Knob. It houses an M4 Nut (ISO 4032) for screw in fixture and is compatible to the IKEA screws. The inlay snaps right in with some pressure, you might need to clean up some leftovers from the support since it fits nice and tight. You should here two clicks once you push the inlay in then it its tight. Prints come with a thin support disc that should peel of just fine. Make sure to cut /drill through the support material of the shell print… ;) Printed on a Replicator 2 Sailfish with @100micron sliced with RepG (whpthomas profiles) at 30% infill with 4 Shells for solid colors…