About this 3D model

Home axis first! ( I raise z a few mm ) So using repetier with proper build area set in firmware did not move beyond the envelope on a smaller printer than this file is made for. So I feel safe enough to post this and let you assume the risks of damage if something is not right in your settings and it does hit an endstop or something. I did it the first time i ran it on Y because I didnt home first. This one uses all three axis , I ran in dry run mode. Keep a close eye on it the first time you run it and be ready to hit emergency stop and recover it if it moves outside your envelope, but it ran fine for me and a friend with a smaller printer than me, it just reverses and goes the other way.