About this 3D model

I love damm301's Winterfell and it's relatively easy to swap the filament after the base finishes to get two colors but I have a dual extruder and wanted to take advantage of that. I also fixed the pathway which overhangs on the front. If using MakerWare remember to say 'no' when it tries to put the top part on the print bed. I did this at 5% fill, 2 shells, .1 layer and 50mm/s. I think it could benefit from printing slower. * There is another dual print on Thingiverse but it had flipped normals and most of the base plate still attached to the buildings.