About this 3D model

Holds a power supply (or a similar shaped box) to a wall. Obviously you *dont* want it to fall! Make sure it is secure!(your safety is your responsibility) You'll have to fit it to your situation. Which is why i havent provided the `.stl`. To be honest, this is quite involved. `pl`, `pt` are the plank length and width respectively. If it is a general box, `psl`, is the length. `pshf` and `pshb` are the height front and back, not 100% if that works you could just set them the same. `wd` is the distance you have between the plank and the wall. `dx`,`dz` are respectively the distance of the box from the wall and plank. You can use tape when it is too big. And a file to make it bigger if too small. In some cases double-sided tape may help too. I got the location of the screws wrong! `sfd` and `sbd` are supposed to be respectively the distance of the screw holes from the back and front.