About this 3D model

WARNING DEPRECIATED: Replaced by http://www.thingiverse.com/thing:80425 Experience feedback on printed part: - Bearing clips worked perfectly - Bearing angles worked well no play! But 0.25° is to much and the carriage did not travel freely - Belt mount did not print corectely Enlarged Rostock Carriage from Jcrocholl modified to: - Take 12x1000mm smooth rods and KB-12-WW Linear Bearings - Should clip the bearings (Not yet tested) - 0.25° bearing holder angles to compensate play - Changed groove to improve fabricability - T2.5 self locking belt mount based on belt_coupler_v6 from Okatake