About this 3D model

This OpenSCAD script will generate a simple one piece fixture to hold Wensi's PV layer's PV cell, PCB and supercap. This is using the slightly newer layout and SCAP propsed on the 17th August 2011 Author: Mark Gaffney Version: 2.2 Date: 2011-09-16 Todo: add thin infill for hollow sections to improve printability make slide in PV version make 2x corner 1 middle tab PV version make screw post PCB version make pin post PCB version make mushroom post PCB version move holes for SCAP pins (2x dia=0.6+blah separation=~10-blah dist_from_bottom~=2.5-blah dist_from_sides=5-blah) and PV wires to more logcal place, also change to square, triangle or teardrop shape for better printability remember the SCAP is now a table profile with dia~=10.5 Warning: there is no top part for this Changes from previous versions: 2.2 - Change cutout for trapezoidal/pyramidal shape 2.1 - Fixed some vlaues to place the support posts in corect location (up +1mm) scap leads Right +2mm - increased post diameter for the two along one side slightly 2.0 - New layout (PCB rotated 90Degrees) and larger SCAP - change pcb_l 30->35 pcb_b 35->30 - change scap_l 23->20 scap_b 15->22 scap_h 5->10 0.8 - add thin infill for hollow sections to improve printability 0.7 - moved entire structure above z=0 plane (no longer a destroyer of belts) - added mouse ears 0.6 - made thinner - fixed incorrect measurements for PV panel 0.5 - Added holes for wires between sections 0.4 - Removed plastic from centre of pv area to speed up print 0.3 - Fixed error with cutout translates due to misuse of separation and clearance variables - Fixed error with second half of calculation of total _b using max() where I forgot to include separation 0.2 - Added support posts 0.1 - First attempt