About this 3D model

Speed Loader (6 Round) .38 Special / .357 Magnum This is a six round version of my other 3D Printed Speed Loader. This was done on request so I can’t test it personally as to whether it fits (insert revolver model here). The cylinder spacing dimensions for this were taken from a HKS 10 speed loader though. There are only three pieces to the speed loader and it is held together with a single 6/32 x 1/2" button head screw. I tapped the hole before inserting the screw but you might be able to just self thread it in. The lock has to be inserted correctly for it to work properly. It will fit in four separate ways but it will only work correctly in two of the positions so a little trial and error might be in order. If the lock is inserted in one of the correct ways turning the knob clockwise will release the shells. If you prefer it to release with a counter clock wise twist like me just reverse it 180° when putting it together. The nubs on the lock may wear out after time I haven't tested it that much yet. NOTICE - My files and designs are all Copyrighted © and are exclusively for private and personal use. Even if you purchased these files that Copyright means you are NOT allowed to sell the model or any derivative of the model, or prints of the model for economic or financial gain.