About this 3D model

This thing was made with Tinkercad. If you have a Generation III Prius (2010-present), you can pop off the UGLY wheel covers to release the alloy beasts underneath. Except - you'll have a hole in the center of the wheel that begs for a decorative cap. This is precisely measured from the Toyota part number 42603-52110 (pictured). This has the iconic power symbol embossed in the top of the wheel cover, as found on the power button of your Prius. More info: http://en.wikipedia.org/wiki/Power_symbol More photos; http://www.flickr.com/photos/theschlem/sets/72157632696775253/with/8449866372/ Also fits Yaris, Vios These and other center cap designs, for GenII and GenIII are available through Shapeways: http://www.shapeways.com/shops/bitforge?section=Prius+Wheel+Center+Caps&s=0 ___ **ATTENTION** This work is licensed under the [Creative Commons - Attribution - Non-Commercial license](http://creativecommons.org/licenses/by-nc/3.0/). This license applies only to the files and documents available for download from the **Thing Files** section of this Thing. **All other related content (photographs, videos, and verbiage such as contained in "Description" or "Instructions" ) are excluded from this license. with all rights reserved, unless specifically available for download** This notice constitutes a clarification, not a change, to licensing for this design.