About this 3D model

We picked up a Ryobi E49CM01 Power Meter and plugged it into the back of our Thing-O-Matic (MK7), recording data under various conditions. Next step will be to crack the device open and attempt some direct logging as opposed to the otherwise tried and true "Look and Type" method. Here are some highlights:Idle: 10 WattsEnable Button from RepG Control Panel: 44.75 WattsMaintain 100C on Print Bed: 41.75 additional Watts above IdleMaintain 220C on MK7: 46.5 additional Watts above IdleDuring a Print (MK7 = 220C, Bed = 100C): 107.75 WattsCost of 8hr Print @ 7 cents per kwh: $0.06All our data is included here but I would really encourage going here:http://www.protoparadigm.com/2011/10/makerbot-thing-o-matic-power-consumption/and reading a short write up that can give a better presentation of the data. We should have similar numbers for the Ultimaker and Mosaic shortly.