About this 3D model

These marble run components were created to have my 7th-grade students explore and practice with a magnetic marble run wall. They were then asked to create their own components using Tinkercad, which we eventually printed out and gave to the lower school for their marble run wall. If you'd like to read about the project, see: http://www.creatorsstudio.org/special-projects/category/marble-run Most of these models were designed to print without supports. I used a Lulzbot Taz 6 with either PLA or NGEN filament. Magnets were glued on to the pieces afterward. Please Note: Model #7 did not print well on my Taz 6, all others were fine. ** The Marble Run Catcher was designed by one of our Lucas Scholars in summer 2016. (http://lucasscholars.org)