About this 3D model

This is modification / derivative of stelocta 3219 by wootfish. I had trouble printing the original due to the thin bottom edge. So I created a 50 mm tall stelocta in AnsysEd, but truncated the bottom 4 mm. "make_full_stelocta.mac" is an ansys script to create the geometry of the full stelocta UPDATE: If you still have problems printing the version above, try "stelocta_notched_100709.stl" below. It has a notch in the bottom to break up the big bottom "X" layers which tend to curl up. See last two figures in white plastic.