About this 3D model

Miscellaneous add-on parts for [BAH Nemesis](http://www.rcgroups.com/forums/showthread.php?t=2226655): - Solid Front/Rear Sidewalls - Hide and protect forward components - Rear Sidewalls - Design allows for air flow and holds bulkhead - Rear Bulkhead - Easily replaceable and expendable part to mount SMA antenna. - Antenna Tube pivots (coming soon) - Allows folding protection of whisker antennas found on FrSky D4R-II. See [stacking Rx tray](http://www.thingiverse.com/thing:444796). - Utility Plate - 36x36x1.5mm general plate for insulating PDB from CF frame... or general use. __Print Instructions:__ - Use brim to help sidewalls adhere to printbed. Lower fan settings and allow sidewalls to cool after print to reduce warping. - Extra print tabs designed on Rear Sidewall STL for better adhesion, again use brims. Remove print tabs before installing on Nemesis. __Install instructions:__ - Slip the sidewalls over the existing standoffs - Rear sidewalls have cutouts at bottom for clearance of bobbin screw & hex nut. - Rear bulkhead slides into the sidewalls. Separately printed and detachable for easy replacement if damaged in a crash. - Antenna Pivots require an M3 hole in the middle of the first battery strap slot (as the plate narrows). Use a M3 screw and hex nut, optionally a lock washer helps to keep tension on the pivot. if using lock washer, a nylon washer between the pivot and top plate can help movement while holding position. __Usage Instructions:__ Antenna Pivots are designed to be installed so that the antenna tubes fold to a stowaway position above the plate. Open fully (butt against top plate) to create a consistent V-shaped horizontal right angle.