About this 3D model

This is designed to be mounted on a 1" wooden dowel. The connector has two small screw holes. I don't have the screws on hand, so I couldn't tell you the size. The mace head itself is made to be glued on, though I am thinking of doing a slight redesign and adding a through hole of some sort. I designed this to be printed without any support and originally planned it to be printed in colorFabb bronzeFill. Since I've owned a printer for all of three weeks, however, I was only able to get the connector to print correctly. The mace head here is done in PLA and painted with a hammered metal spray paint while the connector is in the bronzeFill. I have also uploaded the head cut in half as well. Anyway, this is my first design and I'm still teaking, so comments and criticism are welcome! Edit: I'm sorry to the people who have already downloaded this, but I have discovered a slight flaw. The topmost screw hole being aligned with the beginning of the interior cone has cause my haft connector to snap off. This could have been because of the inherent structural weakness of me placing the screw hole where overhangs begin, me torquing the screws down too hard into the dowel (which I did) or some misunderstanding on my part regarding how to print in bronzeFill properly. Either way, while twirling around my new toy, the haft separated in two. Since the mace head takes 31 hours to print (at least at my settings) I recommend printing the head first. I'lll have a new haft connector up tomorrow, with a redesigned hole scheme. Edit2: New haft connector is up. Works great.