About this 3D model

Car mount (ventilation fins) for iPhone 5/5S/SE with passage for jack and ligthning port. The holder is designed for phones without shells. Simply glued two-piece assembly. Approx. 1 hour 45 min. printing time. The iphone slips in and out without forcing and is perfectly held in place. TIP FOR PLA PRINTS: gradually subject the fixture to a temperature of 80°C for 15 minutes. After this, the PLA will be able to withstand a temperature of around 110°C. This is very important, as it will be attached to your car's heater grilles.