About this 3D model

Dock for Moto G phone. There is a fair amount of friction in the connector so the phone needs to be pressed down instead of just dropped into the dock. Requires the following parts * 6-32 set screw, approximately 1/4 inches in length (to hold the cable in place - do not over-tighten) * StarTech right angle USB Cable http://www.amazon.com/StarTech-com-Micro-USB-Cable-UUSBHAUB1RA/dp/B003YKX6WC (if you use a left angle cable, you will need to mirror the part. * A few inches of 1.75mm NinjaFlex filament for the base (red in the pictures) This design tends to warp when using ABS, I'd recommend a non-warping plastic like PET or PLA.