About this 3D model

Inspired from http://www.thingiverse.com/thing:337998andhttp://www.thingiverse.com/thing:167650 I have designed an own solution as combination of both approaches. I have sliced with cura because of the inner diameter bug of slic3r. There is one critical zone which would support material normally. I have printed without support material (see picture - no risc no fun ;-) ). Could be that you need support material if you use an other slicer. The Micrometer I have used I shoot on Ebay for 5 EUR. The smaller Microscrews which are normally foreseen for this kind of machines are about 25EUR or more. The Microscrew I got has not the best quality. The hole for fixing screw is not drilled 90° so it looks bad but it works. Edit:The Thingview looks like the hole for mounting screw is missed. In Designspark the hole is ok and Cura slices it correctly. No clue what happen there You need: 2 M3x20 screws with nuts for the switch 1 M3 screw for fixing the micrometre in mount 1 M4 Screw (perfect would be one with grip profile) for fixing the micrometre after setup Z all other things you can use from original solution Required parts:New z-Motor-Holder for the Velleman K8200 or 3Drag http://www.thingiverse.com/thing:144813