About this 3D model

This Kit allows you to install 4x2mm PTFE filament guides on your extruder on the following printers: CTC Creator Dual WanHao Duplicator 3 & 4 FlashForge Creator I,II,III & X MakerBot Replicator 1 This kit is optimized for [my spring loaded Drive Blocks][1] but should work on other drive blocks as well if they perfectly align with their in and outlets to the nozzles. **The Kit contains:** Extruder Plate with cable manager and sockets for M6 Push-In connectors for 4mm tubes. A back mount module with cable manager and sockets for M6 Pneumatic Push-In connectors for 4mm tubes. All M6 sockets are just core holes for M6 and you need a thread cutter to finish them. **Requirements:** 1m 4x2mm PTFE tube cutted into 2 pieces _(2mm inner 4 mm outer diameter)_ 4x M6 Pneumatic Push-In Connectors for 4mm tubes 1x M6 thread cutter [1]: http://www.thingiverse.com/thing:231310 "My spring loaded Drive Block"