About this 3D model

1/14 Radio-controlled tractor 07R EJJI3. 11.05.2026: - Added files to use Hobbywing Fusion SE motor with planetary gear. - Added Top link 08.02.2026: Rim for blocher 8096 and 8099 tires added. Check out the introduction video of the tractor here: https://youtu.be/LDaGsCdGCjI Drive video: https://youtu.be/33Fb2PuLmgg Technical information, as well as functionality: - Animated building manual. - Wheelbase: 206.5mm - Lenght: 352mm - width: 194mm. - 4 Wheel drive - Tire: ø120 - 147mm - Lift on front cylinders - Three-point hitch at the rear with functional top link - Electric differential lock on the rear axle - Pivoting front fenders with realistic stop angle - Movable front axle, tilt side to side - All metall driveline - One center engine that drives the entire tractor. Motor: Hobbywing Fusion SE motor with planetary gear OR Servonaut GM32U450. 12V - Lesu metal front and rear axle. - Approximate total weight with weights in 3-printed tires 6kg NICE TO KNOW BEFORE YOU BUY! - The building is somewhat advanced, some experience with 3d printing and model building is recommended. - Estimated construction cost 17.01.2026, 562,- euros, excluding local VAT, shipping on some parts, as well as purchase of files and approximately 2kg of filament for printing. - 3D printed TIRES in TPU. I have printed tires in Fiberlogy FiberFlex 30D, may need some experience printing skills if you not have a modern printer. Shoe sole active rubber, which provides a lot of friction. - Due to modern slicers, no time is used for rotating files in the correct printer direction. BAMBU Studio users have completed projects for their respective folders. Sorry for those who don't have auto rotate!