About this 3D model

This is a printable top slide that fits Umarex HDP50 / TP50 Gen 2 markers. It has no added function to it so it's purely a visual modification. It replaces the original slide. No additional hardware needed. It's worth noting that the pressure indicator pin is not visible from the outside when using this part. PRINTING Requires a 210mm tall print area. The slide comes in its recommended orientation for printing. Supports should be enabled for better results. There are no other print setting requirements but lower layer heights will look better. If you encounter sagging of the pin hole, you can drill it with a 3mm drill bit. The part is a tight fit to avoid any wobble. The inner ledges will sort of clamp on the internal shapes of the marker, making it a bit stiff. Don't be afraid to use a little force to install and remove the top slide! This part is licensed under a "CULTS - Private Use" license and can not be used for commercial purposes. Let me know if you run into any issues or have any questions!