About this 3D model

Enjoy 3D printed wellness for your feet. Using this during your TV session, in the garden or other beloved places. Without batteries, no maintenance is required. Just print, assemble and wellness. I like bioplastics so i used PLA for all parts. Which seems to me tough enough for a normal application. The "Massage Roller" has a housing for 608RS bearings. It's optional to use them. If you decide to not use bearings it can be happen that it makes squeezy noise when rolling. This can be avoid by applying a little bit of a non-mineral oil to the Support Shaft's. Please be aware, once assembled it's very hard to disassemble it again without breaking it. It take roughly 21 hours to print all parts, the material consumption is around 110g for the minimum requirements.