About this 3D model

Here is a basic Tsuba design for a Katana style Bokken (bokutō 木刀). It was based on the existing Tsuba on one of my Bokkens. While there are already Tsuba designs on other 3D websites, I thought I'd make one just so I could have a different colour on my own Bokkens. I for some reason like making my things from scratch rather than downloading existing designs. Print time at 0.15mm with a 30% infill was about 1 hour 50 minutes. I normally use 15% infill for my prints, but felt that a higher infill would give better impact resistance. Of course it all still depends on the material used, which in my case was PLA. The design measures at 7.85mm x 7.85mm x 6mm, and as shown in the photos fits my bokken. It was a tight fit, but the original this was based on was a tight fit also. Both STL and OBJ are included.