About this 3D model

Christmas decoration that certainly is no moon. The bottom part can be twisted to toggle LED lights. Parts: a 9V block battery, a MTS-1 toggle switch, 6 x 5mm LEDs, 1x M5x8 allen key screw,( and a short allen key for fastening ), a green 3mm LED with an 330 Ohm resistor for the laser aswell as some basic soldering skills if you want to get it illuminated I added some Neodymium magnets to mount it. I'll upload a picture of it later. Assembly: An album of the building process can be found here: http://imgur.com/a/J0H66 Print settings: Printed it in natural PLA with 0.2mm layer height and a 0.4mm nozzle. No support was needed except for the upper dome part. Print every part 1x.