About this 3D model

With this beautiful female alien on your wall, your room will look like a sci-fi movie scene while keeping your headset and controllers organized! ?? ➡️ Check out the male alien version ? here! The female alien includes printable eyelashes that fit into the eye sockets. Simply insert the eyelashes, then the eyes, and use a hairdryer to gently bend them into place, giving the model a beautiful and feminine touch. It also includes hands that holds controllers, it has been tested with Xbox, Playstation and Nintendo Switch but it might be compatible with others too. And as usual the head can also hold headsets. ---------------------------------------------------------- Wall Mounting Instructions: To mount the Female Alien to the wall, you will need 6 screws in total: -2 screws for the head and bust-2 screws for the left hand-2 screws for the right hand Measure and mark the positions on the wall before installing the screws. Once the screws are in place, adjust the screw heads as needed until all parts fit securely and sit flush against the wall. ---------------------------------------------------------- Printing Times & Filament Usage: - Head: 12h 360grams- Hands: 7h 230grams- Bust: 6h 170grams- Eyes + Eyelashes: 1.5h 30grams **Total:** ~28 hours • ~800 gPrinted using Elegoo Rapid PLA+ ---------------------------------------------------------- Includes: -Printable eyelashes-Printable eyes-Printable head and bust (Includes a smaller bust too)-Controller holder hands!-Pre-configured Factory Files for Bambu Studio, and also Factory Files for Snapmaker Orca-Instructions PDF ---------------------------------------------------------- All IK3D designs are Copyrighted and for PERSONAL USE ONLY. To sell prints of my models, you can subscribe to MMF, Patreon or Thangs with the commercial tier membership. Digital files can’t be shared or resold!