About this 3D model

The Flintstones are one of my favorite childhood cartoons. Dino was modeled in Blender, sliced using Simplify3D and printed in ABS on a FlashForge Creator X. I also used a GeckoTek plate to ensure perfect adhesion of the parts to the bed. If you have the proper filament colors, no painting is required. The model is 24cm tall. Enjoy, and I hope you have a "Yaba Daba Do" time printing this! --------------------------------------------------- 3D PRINTING SETTINGS Printer: FlashForge Creator XRafts: YesSupports: YesResolution: .2mmInfill: 10% Notes:Only a few pieces require some very minor supports and a raft. The majority of pieces do not require either. Refer to the notes below for details. I print all my models using 2 shells. ColorsBlack:eyeshairspot1spot2spot3spot4spot5 Purple:bodyheadarmrarml White:eye_whitestag Beige/Pink/Skin (I used a light beige):mouthnose Blue:collar Red:tongue Extra notes for printingPieces requiring minor supports around the low curves at the base:armr, arml, mouth. Pieces that may require a raft or brim (I use a brim):tongue, head. I did not use a brim on the nose, but you may needed one. AssemblyAssembly is fairly straight forward, refer to the assembly diagram in the pictures section. I've listed a detailed step by step process below if guidance is needed. *be sure to clean off any excess brim from the first layer if you use a "squish factor" for adhesion to the bed. -Glue armr and arml to the body-Insert and glue the spots as per the diagarm-Hook the tag through the collar-Insert and glue the collar to the body-Glue the mouth to the head-Glue the tongue to the mouth-Glue the nose to the head, resting on the bridge of the mouth-Insert the eye_whites, making a note of left and right (depressions for the eyes face toward the middle)-Glue the eyes to the eye_whites. making a note of left and right eyes (there is a slight angle on each eye that should face towards the middle so that the eyes rest closer to the middle)-Insert and glue the head into the collar.-Glue the hair to the head. After careful trimming of any first layer brim, the hair should fit into the head.