About this 3D model

This is a P1Touch Corner Stand, which I put together and modified from two models. I find the touch screen based on the Cheap 2.8 inch ESP32-2432S028R quite practical and like to use it as a small extension next to my mobile phone and PC. The project can be found on Github: GitHub - xperiments/p1touch: Bambulab P1 Series Touch Screen A newer project related to this is x-Touch: GitHub - xperiments-in/xtouch Update 3.0 I have added your new version of the cladding. It now fits WITH an SD card. Both Micro USB and USB-C can be connected… (Upgrade 4 - xTouch) Info-Update xTouch-Project needs an SD card to store the WIFI information. This was not factored in in the current case and therefore an SD card only fits “just right”…. Update to follow. Update 2.0 The can now be guided through the stand into the interior of the enclosure. This allows it to be connected to the existing USB of the printer for power supply. NOTICE: THIS IS A SIMPLE PRINT. AS YOU SEE IN THE PICTURES, MY MODEL STICK VERY GOOD ON THE BED. SO BEFORE YOU GIVE BAD RATING TO MY PROFILES, BE SURE YOU HAVE A GOOD BED ADHESION AND ASK TO YOURSELF, WHY YOU DON'T HAVE A GOOD BED ADHESION. I DON'T WANT TO UPLOAD A LOT OF PROFILES FOR EACH SINGLE PROBLEM YOU HAVE AND FOR EVERY SINGLE MODEL! EVEN YOU WANT TO SHARE ONE, IT DOESN'T MAKE SENSE FOR THE SIMPLE MODEL ITSELF! PLEASE, LIKE I SAID THE MODEL STICKS ON THE BED EASY! NOT ALWAYS REDUCING THE SPEED CAN HELP YOU TO STICK EVERY MODEL ON THE PLATE! THANK YOU FOR THE UNDERSTANDING!