About this 3D model

Minolta Camera 16mm Film Cartridge Printer: Bambu P1P Nozzle: 0.4 Profile: 0.12mm Fine @BBL P1P Filament: Overture PLA, Black Model must be printed using a 0.3mm wall width to insure that the fit tolerance is maintained. ---------------------------------------------------------------------------------------------------------------- I have added an image of the cartridge with a strip of flocking tape attached to each side of the film pass through slot. The flocking tape fits just right to stop 99.9% of the light from entering the film cartridge and still allow the film to slide in and out. The flocking tape I used was VCC Flocking Tape [Non-woven Fabric] (FLOCK-1): 1/2 in. x 300 in. (Black) https://www.amazon.com/J-V-Converting-FLOCK-1-BLK2833-Flocking/dp/B01B5FNRA8?ref_=ast_sto_dp&th=1