About this 3D model

I whipped up this wheel so that I could mount some 1.9 crawler tyres on the front of my RC hot rod for a dirt outing. This version has significant negative offset (rear bearing face is flush with the rear edge of the rim) For assembly of one wheel you need:(5) M2x12 mm screws(5) M2 nuts(2) 5x11x4 bearings/bushings (common in tamiya buggies) You may want to scale the ring slightly, either to make it larger diameter, or wider, but since this is a freewheel I haven't had any issues yet. Please note the CC-Attribution license, you are welcome to sell prints of this design, you only need to credit me (either link to this page, my webpage http://www.ossum.co.za or my facebook page https://www.facebook.com/ossumdesigns )