About this 3D model

DaVinci 1.0 Pro AiO - PLA Fanduct inspired by ChatToBrian`s Exhaust Fan Duct, i wanted to design my own one. ;) 2x Fans 5015 50x50x15mm 12V1x Switch KCD1-101 2Pin1x LED 5mm1x LED Holder Clip 5mm1x Resistor 470 Ohm (12V/ green LED)// Resistor 560 Ohm (12V/ red LED)2x Screws M3 / 50mm2x Nuts M32x Zipties Test completed / File updates! Testing to load an unload Filament -> OK! Testing while printing -> OK! Testing to set/calibrate z-axis -> OK! Testing to switch to engraving module -> OK!