About this 3D model

Optional models are available at the following address: https://cults3d.com/:1096059 If you appreciate my designs, please like and share them. If you really enjoy them, consider buying me a coffee. https://www.buymeacoffee.com/kjbturok https://www.paypal.com/paypalme/ChinadlaConchinchina Content: 1x Rectangular drainer 1 (small and two spaces). 1x Feet (7mm high). 1x Feet ( 12mm high). The feet are optional in case your sink is above your countertop. I have included two feet with different heights. If you require a specific height, please ask me. Printing on PLA, ABS, ASA, etc. It is recommended to print at a layer height of 0.16 or lower. Please note that the higher the quality, the better the water will drain. You can print with a variable layer height leaving the drainage area at the best quality possible on your machine and the one you desire for the rest of the piece. Activating the smoothing of upper layers also helps to improve water evacuation. Infill 20%, three perimeters, three top and bottom layers. Supports are needed only in the area where the feet are placed. SPANISH You can find optional models at the following address: https://cults3d.com/:1096059 If you like my designs give it a like and share. If you like them a lot invite me to a coffee. https://www.buymeacoffee.com/kjbturok https://www.paypal.com/paypalme/ChinadlaConchinchina Content: 1x Rectangular drainer 1 (small and two spaces). 1x Feet (7mm high). 1x Feet (12mm high). The feet are optional in case your sink is above your countertop. I have added two feet with different heights. If you need a special height, ask me. Print on PLA, ABS, ASA, etc. It is recommended to print at a layer height of 0.16 or lower. Keep in mind that the higher the quality the better the water will drain. You can print with variable layer height leaving the drainage area at the best quality possible on your machine and the quality you want for the rest of the piece. Activating the smoothing of upper layers also helps to improve water evacuation. Infill 20%, three perimeters, three top and bottom layers. Supports needed only in the area where the feet are placed.