About this 3D model

These mounts can be expensive and they seem to get lost very easily, so… another request from my IT dept to design a 3D printable version.Fits into a standard Flash Shoe mount, with Ninjaflex clamp ring mount and collar to isolate the mic from any vibration (tan coloured parts). All part are either thread or slot together - no glue should be needed.All parts print without supports at 0.2mm (or higher for threaded parts).Print the Flash shoe mount with 100% infill for strength.The mic clamp is joined at the hinge by a metal 'pin' (see parts photo) i discovered a cut down large paper clip worked great (1.75mm dia). Print in a strong filament of your choice.I used Faberdashery Classic Blackhttp://www.faberdashery.co.uk/products-page/print-materials/classic-black/and Caramel Ninjaflex http://www.fennerdrives.com/%20ninjaflex3dprinting/_/3d//. NOTE:This mount hasn't been fully tested, i will post updates if parts design evolve. Enjoy!