About this 3D model

Seriously cool snake that comes off the build plate wriggling... prints really well on a Replicator 2 (refer instructions) Make sure your levelling is correct and this will almost wriggle it's own way off the build plate... use 3 shells and 35% fill at Std. resolution (prints great on a Replicator 2).No Support or Raft required. However, there is a small amount of manually added support under the fangs to remove after printing...To make your snake colourful use Z-Pause (at original size) as follows:Start with white for 2-3 layers then change to snake main colour chosenZ-Pause at 2mm and change to black for fangs main colourZ-Pause at 4mm and change to red for fang tipsZ-Pause at 5mm and return to main colour for snakeZ-Pause again at 9mm and change to diamond pattern colour chosen