About this 3D model

The 'MouseTrap' is a small but simple device that keeps your wired computer mouse cable neatly coiled at the preferred length for use and/or when being transported. The design fits common wired Mouse cables (3.25mm) so is a fine/detailed device to print. As some cables may vary slightly, and not all printers print the same, If you print a 'MouseTrap' and find it is either too tight or too loose on your Mouse Cable (it should be a snug press fit into the clips) uniformly scale it up or down slightly until you get a snug fitting result. This is a small and easy print. On a Replicator 2 /5th Generation Replicator they print in less than 15 minutes including Raft. Using Raft is recommended as it is a small print. The design allows for it to be printed without support (PLA). Please refer to print settings for additional details. Note: If you like this check out all my other practical and fun designs.... and post images of them in use!