About this 3D model

Hey everyone! I just started getting into electronics and design after a bit of 3D printing. This is my first official project with proper documentation, measurements, and testing around a Raspberry Pi. The design is purposeful where the SSDs stick out and with cables going around, wrapped in a cable sleeve for an interesting look. The OLED helps to monitor the device and to check ip. Updates: 9/22/2023: Initial release Parts used: 1x Raspberry Pi 4B 2gb 1x OLED 0.96 i2c display module Required cables (ethernet, power cable, etc.) 1x 60mm 5v USB fan 2x USB to SATA cable 2x SSD 2.5" 2x M3 14mm-16mm screw 23x M3 6mm screw 25x M3 4mm screw 2x M3 nut https://www.amazon.com/Sabrent-2-5-Inch-Adapter-Optimized-EC-SSHD/dp/B011M8YACM/ref=sr_1_4?crid=XHDE9KMMJRLB&keywords=sata%2Bto%2Busb%2Bconnector&qid=1695431511&s=industrial&sprefix=sata%2Bto%2Busb%2Bconenctor%2Cindustrial%2C86&sr=1-4&th=1 All up to you but this is how I printed mine: Printer: Bambu Lab P1P & Elegoo Neptune 3 Plus - for the inner panels Some adjustments have to be made in terms of the base Walls: 4 Top/bottom: 4 Nozzle: 4mm Layer height: 0.16mm Infill: 15-20% - any pattern Supports: ON for outer panels - tree Brim: ON for outer panels Here are some assemblies to help install and notes: SSD side bracket is to be mounted inside, keeping the 2 SSDs in place 60mm USB fan apparently can't be controlled so I'd recommend an adapter with a physical knob attached There are 3 versions of Front Panel Outer for OLED, no OLED, and additional airflow. SSD top panel bracket only needs 2 screws for SSD on the top as it's stable enough Please leave any comments/feedback as they would be greatly appreciated!