About this 3D model

Summary Two piece stand I created for my wife's Samsung Active Watch. The two pieces assemble with a M4 x 12mm screw and hex nut for adjusting the angle. There is a slot in the top of the stand to hold the hex nut during assembly. I used a higher infill in the base (85%) to increase stability. 25% infill for the holder works just fine. I have printed this both in .1mm (pictured) and .2mm resolution successfully. I suggest using supports everywhere for the best results. Print with the base as it stands and the holder with the flat side down. Thread the USB connector through the slot in the holder and then the charger will install with a snug fit in the cavity. Print Settings Printer: Maker Select V2 Rafts: Doesn't Matter Supports: Yes Resolution: .1 - .2 Infill: 25% - 75% Filament: Hatchbox PLA Silver