About this 3D model

Summary A minimal angled desk stand for the Focusrite Scarlet 4i4 so the knobs are a little more accessible and visible. 15cm wide by 10cm deep Can be used for other Focusrite devices as well. Feedback is welcome! Updated Version 2 Uses far less filament and less print time Old Version 1 This version was to rudimental and since the base was big and useless it used a lot of unnecessary filament. Version 2 resolved that. Print Settings Rafts: Yes Supports: No Resolution: 0.3 Infill: 10% Filament: BASF Ultrafuse Pick your flavour Post-Printing Added some vinyl feet to prevent from sliding on the bottom Added some vinyl on the touching point to prevent sliding/scratching.