About this 3D model

Size chosen to fully utilize the available Bambu P1P plate size. (For utilizing the full 256x256 plate size, see instructions ) Height was chosen to coincide the official LEGO box height (150mm) You can also check out my other big LEGO box . It's prettier, but more wasteful. Optimized it to use minimal amount of filament: Cover: Infill: Lightning, density: 25% Brim: No brim Support: normal(auto) Filament used: ~200 gram P1P print time: 6.5 hours Box: Infill: Grid, density: 25% Brim: Outer only, 5mm Support: None Filament used: ~460 gram P1P print time: 11 hours Note #1: Prints fine in regular P1P speed, no need for reduced speed Note #2: I recommend using a glue stick on the entire print surface, because the model is very wide (takes up the entire print surface) and you don't want it to bend while printing.