About this 3D model

I needed a simple and lightweight front cover to protect the joysticks and the screen when traveling light, so I made one. Two versions: Full front cover (this one), and partial front cover, without the front corners ( link ): PARTIAL FRONT COVER WITHOUT THE TWO FRONT CORNERS CAN BE DOWNLOADED HERE Prints as a single piece in the P1P and X1C (and any larger printer) Very light, weights only 60g printed! Smooth corners to not snag into other stuff when thrown in a backpack Very thin, can flex slightly to fit snugly around the deck If you prefer a looser fit, increase the width by 1mm. That is, the widest measurement (leave height and length the same). The standard model has a very tight fit and need some flex to install and remove. I tested in PLA and PETG. PETG fits as well and is more flexible, but the finish is worse due to the supports. Supports required. I can print with only a few supports depending on angle, but there aren't many choices given the size and complex shape. If you can print without supports on a larger printer, let me know! Must be positioned diagonally on the bed to fit on the P1P and X1C: