About this 3D model

This is a wall mount for the Bosch Powerpack 725 Since I couldn't find a wall mount for the Bosch Powerpack 725 , I created one myself. Inspired by SeniorRossi ( https://www.printables.com/de/@SeniorRossi_566649 ) wall mount design, but unfortunately, it only fits Bosch Powerpack 500 batteries ( https://www.printables.com/de/model/414838-bosh-powerpack-500-wall-mount ). Considering the battery's weight of 4 kilograms, I focused primarily on stability during the design and printing process. For the printing parameters, I selected: 4 wall loops and used a honeycomb infill with 45% density. As you could probably go a bit lower and save time and material I reduced the Infill to 40% in the print profile here. In this final print I used Tree Support but my test prints before where done without any support and came out fine. For printing I used Bambulab PLA Though in black. On my Bambulab printer, it took 5 hours and 40 minutes to complete the print (withh support). Any comments or suggestions regarding this design are appreciated.