About this 3D model

A neat and easy to install octoprint enclosure to fit an Ender 5 / Pro Unlike other similar designs the base of this enclosure is separate from the upper half so installation is much simpler This design is to suit a Raspberry Pi 3B+ You will require: 4x M3 x 10mm countersunk bolts - For joining the two halves 4x M3 x 10mm bolts - For mounting the Pi 8x M3 Nuts Technically the pi needs smaller bolts but M3 bolts will fit with a little persuasion. The screen should mount with the original bolts. To power my Pi I use an "Up Angled" Micro USB Male to USB cable which is plugged in to a Buck Converter mounted inside my Ender 5's Enclosure. You will most likely need to do something similar. Print Settings Rafts: Yes Supports: Yes Resolution: 0.2 Infill: 15 Filament: Anycubic PLA Red Notes: I don't normally use a raft to print but for the upper half it proved necessary to stop the thin edges lifting off the bed. The upper half will also require supports, I used tree supports. Rotate both parts to print with the base on the bed