About this 3D model

This is a replacement stronger propeller and nose cone for a Quick Build Mustang P-51D Model Kit (J6016). The original propeller lasted just minutes in the hands of a four year old. This design replaces both the propeller, nose cone and the shaft with a stronger design. It still wont survive a four year old but at least I can print replacements :D Print the Nose cone vertically on its tip with a raft, 100% infill The propeller may need a little sanding of the center hole depending on how well your print came out. If you found this useful, please leave a comment! Tips are not expected but always welcome. Thanks, Enjoy! Print Settings Rafts: Yes Supports: No Resolution: 0.2 Infill: 100%