About this 3D model

This is an art tile I made for the wall of my tiki bar. It shows my spirit animal enjoying a stiff drink. Longer print time but few filament changes. I've also found that using a dark blue/purple instead of black will give a nice effect with this print. ---------------------------------- Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm Filaments Used: PLA Black PLA Gray PLA Metallic Gold PLA White Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Gray At layer #14 (1.2mm) swap to Metallic Gold At layer #17 (1.44mm) swap to White for the rest.