About this 3D model

Summary Are you struggling to get the ball off the magnetic cannon? Fingers to big? Nails too long? Then this is a useful tool to remove the ball. It holds a magnet on either side and allows you to easily pick the ball out of the cannon. Printed in PLA. Straight up with a brim. Two magnets are required. 8mm round and 8mm in height. Strength should be N48 or higher. Use a dab of CA glue to hold them in place. A little bit of sanding may be required if you printer produces an elephant foot on the model. Print Settings Rafts: No Supports: No Resolution: 0.2mm Filament: colorFabb PLA/PHA Green Notes: You can print this with a brim. (Optional if you have a very good bed adhesion).