About this 3D model

Magnet Door Handle for Standard Voron 2.4 Frame with 3mm single door and 3mm sealing tape. Installation requires drilling - works only with acrylic glass not plexi(C)-glass. Check yours! What to print: 2x Door Latch 1x Door Handle BOM: 2x M3x8 BHCS 2x M3x6 BHCS 2x M3 shim 4x 6x3 magnets (N52) 2x M3x5x4 heat-set insert 2 M3 t-nuts 2 M4 drill Installation: Drop in M3 t-nuts where the handle should be Insert magnets in door latch (without glue) and screw tight with M3x8 BHCS. Insert heat-set insert into handle (small holes) Super glue the magnets into the handle (mind polarity) - don't worry the latch-magnets can be changed easily Align everything so the door is shut and everything is flush Mark the door-panel from inside where the heat-set insert are Gently drill both holes ( check if your panel is suited for drilling! ) Secure handle with M3x6 BHCS and M3 shim.