About this 3D model

BIGTREETECH Filament Runout Sensor Mount for Ender 5 Plus Required Parts: https://www.amazon.com/BIQU-Filament-Detection-Accessories-Extruder/dp/B08QJFJYLN Set of 4, 2.5 mm screws, washers and nuts that fit the existing run out sensor mount pictured below. Note: you will have to remove the existing run out sensor if you have not already. Build Guide: Print out the bracket from this project. Remove the back plate from the Bigtreetech sensor and set it aside. Retain the screws. 3. Screw the sensor to the mount plate as pictured below.