About this 3D model

Support for plants around a circular base. Fully parametric (see the attached scad file), to print any size. Print upside down, no support needed whatsoever. Scad file parameters: Parameter Description Default value Unit inner_diameter Diameter between the feet - if your plant has some sort of circular base you want to put this support around of, this is the value you're after. This is also what defines the main diameter. 56 mm hole_diameter Diameter of the hole for the plant. Be mindful that depending on the angles below, the opening will most likely be smaller than that. 5 mm ring_width Width of the outer ring. 11 mm supports Number of supports. Less supports will mean a larger opening to the centre hole, as the angle of the opening is the angle between two supports. 5 n/a support_angle Angle each support occupies. Larger angle means larger supports. 15 Degrees support_height Height of the supports 30 mm