About this 3D model

Remix of Squash ball feet for Prusa Mini. All brackets bolt into aluminum extrusions and support the electronic's box. Highlights: Massive Noise Reduction Improved Stability (Lifting the magnetic sheet won't tilt the printer) 6 Support Points without increasing operational footprint. This is inspired in https://www.thingiverse.com/thing:4752965 from jrjonescan, I love the weight distribution and support points choice. But it was too bulky, so I recreated the low profile from Vektor. Print 3x Single Foot (If you are going to use the Spool holder print only 2x) 1x each other model You will need: 6x Squash Balls (double yellow dot) 5x M6 x 12mm Bolts 5x M6 T-Nuts *If using the spool holder setup, you will also need: 2x 608 bearings. Alternatively, you can reuse the originals from the mini Spool Holder. 1x of the Original Prusa Mini Foam Feet (The spool holder includes a slot) Spool Holder: This is a remix of the popular Spool Holder from Max with the Squash Ball foot + the "Filler" Filament Roller. Print instructions .25 layer 3+ perimeters ±30% infill Minimal Support ( set overhang threshold to 5º, so supports is added only to critical areas) PLA / PETG