About this 3D model

A small, strong case with a collection of optional inserts for different uses. Case Use a section of 1.75mm filament inside the hinge to connect the lid to the base. Depending on your printer/setup, this hole maybe be on the tight side or a bit loose. If tight, drilling out the hole may help. If it is slightly oversized, I suggest melting the end of the filament piece with a soldering iron or lighter. This can be a standalone case or you can add inserts for more functionality. Print Settings Base and Lid can be printed with 3 perimeters and 0% infill. Using these settings, most walls will be solid. Optional Inserts Battery Holders AA Holder - fits up to 6 AA batteries AAA Holder - holds up to 8 AAA batteries 9V Holder - fits up to 2 9V batteries Digital Storage Holders - Can be used together or separately MicroSD Card Holder - fits up to 12 MicroSD cards in the lower section SD Card Holder - fits up to 6 SD cards in the upper section Dividers Full Divider - Splits the entire case into 2 compartments Upper Divider - adds 2 compartments on top - Can be used with the Lower Divider Lower Divider - adds 2 compartments on bottom - Can be used with the Upper Divider Nozzle Holders - Can be used together or separately Upper Nozzle Holder - fits 14 standard nozzles (MK8 or E3D V6) Lower Nozzle Holder - fits 14 standard nozzles (MK8 or E3D V6) Print Settings No special print settings are needed for any of the inserts. I used 3 perimeters and 10% infill. The following filaments were used in the pictures above: Black Case polymaker PolyTerra Charcoal PLA Hatchbox Sparkle Gray PLA Red Case polymaker PolyTerra Army Red PLA polymaker PolyTerra Lava Red PLA Yellow Case PrintBed Yellow PLA polymaker PolyTerra Banana PLA Teal Case polymaker PolyTerra Arctic Teal PLA PrintBed Baja Blue PLA Purple Case Prusament Galaxy Purple PLA Fillamentum Lilac PLA Orange Case CC3D Flame Orange PLA+ Inland Orange PLA Green Case PrintBed Green PLA polymaker PolyTerra Forest Green PLA Blue Case GIANTARM Matte Navy Blue PLA polymaker PolyTerra Sapphire Blue PLA